Adobe Audition Current Audio removal tutorial

1, as shown below we click on the AU, "left-click"-"waveform", the establishment of "monorail project" effect is as follows

2, then in the interface we click on the left of the "media browser" to the current sound audio into the left edit, the effect is as follows

3, "left-click"-"Spectrum frequency display", converted to frequency spectrum display diagram, you can see around 15KHz there is a thick red horizontal line, that is, the current sound, the general current sound is in a certain frequency, with the notch filter will have the frequency of the current sound of the line

4, "left-click"-"Effect"-"filter and equalization"-"Notch filter"

5, "left-click"-"Enable 1" Activation node, "frequency" input 15000, "gain" input-25

6, "left-click"-"Enable 2", the node 2 to the node near 1, and transfer 2 nodes, while the point "play", try to listen until the appropriate no obvious current sound, point "OK"

7, after the completion, you can observe the coarse red of the current sound weakened a lot

Well, the above is a small series for you to organize an article on the use of audition to eliminate the current sound method, I hope this article can bring help to the OH.