Photoshop Synthetic flying Flame man tutorial

Final effect Diagram

The first step: open the material

Let's open our character footage first.

Step two: Highlight the dark part

Now that we have started, choose the deepening tool. Set to: Middle tone, exposure: 15%. Because we have to do is the burning effect, so to smear a few.

In the area under the eyebrows, the chin, the nose, the back of the neck, and other places smear. Adjust the brush size with the local to fit your image effect.

Step three: Highlight the highlights

Select the Dodge tool and reinforce the area where the face is light.

Step Fourth: Create a path

Select the Pen tool and select Path.

Enlarge the image and hook it up slowly.

When you are finished, press CTRL + ENTER, and then copy the layer, ctrl+j.

Fifth step: Open the background

Sixth step: Open the Flame picture

Seventh Step: Match color

To allow the flame to fuse the image, we adjust the hue and saturation (Ctrl+u), as set below:

Hue: 0

Saturation Degree:-20

Lightness: 0

Apply the Free Transform tool (ctrl+t) so that the flame appears to come out of the hand.

Eighth step: Polishing the Flames

Select the flame layer and be on top of all layers. Then use the Eraser tool to erase the flames from the surrounding area.

Step nineth: Add a mask layer

Click "Add Layer Mask" at the bottom of the layer palette. Select the Brush tool to set the foreground color to black.

Tenth step: Show arm

Use the eraser tool to erase the flame on your arm and let it show up in some places.

11th Step: Add from the flame reflective

Set the foreground color to be a lemon yellow or any color match the flame.

Create a new layer, and then select the Brush tool to smear on the character, as follows,

When you finish, set the blending mode to color, and the transparency is: 55%.

Step 12th: Add a background

Create a new layer and fill it with orange.

Set blending mode to: color. Opacity is: 36%

The effect should be the following after finishing

Step 13th: Add a glowing background

Create a new layer, then use the Brush tool, and set the brush size: 1350, opaque to 25%. Then smear it on the back of the character.

14th Step: Add Soft light

Create a new layer on the character, and then set the blending mode to: soft light, opacity: 34%.

15th Step: Add Light

On all layers above the letter layer, select the Brush tool and use the following settings. Size in: 97-200, opacity: About 50%, here we draw some light, pay attention not to draw too much.

Step 16th: Change the color of the sky

Create a new layer and name it "blue gradient." Select the Brush tool to set the foreground color to light blue. Use your brushes with the following settings. Size: 1250, opacity: 53%, blending mode: soft light

Now we can see that the background has a blue effect.

17th step: Darken the boundary

Create a new layer above all layers and name it "boundary", fill it with black, then apply the Eraser tool smudge, set blending mode to: soft light, opaque to: 69%

All right, we're done. There are written places I shortened, because he wrote very fine, there are write places can be a pen to carry. Let's look at the final effect.

Note : More wonderful tutorials Please pay attention to the triple Photoshop tutorial section, triple PS group: 249667984 welcome you to join

Category:

• PS Composite Picture Tutorial