Set a wireless route Password

Today, we have seen many friends on the Internet asking questions about the content of setting the wireless route password. So let's talk about the content here. First, let's take a look at our setup platform. This article uses TP-Link Wireless routing as an example. Other Wireless routing passwords are set similarly, And the router part sets the wireless routing password: the router address and access password are only provided by default. Please replace the value set by yourself ).

◆ Open the browser and enter 192.168.1.1 in the address bar to bring up the prompt window for setting the wireless route password.

◆ In the password prompt window, enter the user name and set the wireless route password to admin by default. If there is any discrepancy, the corresponding value should be given below the vro) and press OK. The setting wizard is displayed and the setting page is displayed. You can close the setting wizard and enter the specific Wireless Settings section.

◆ Click "Wireless Parameters" in the left-side list to go to the "Wireless Network Basic settings" page.

◆ On the right page, you can see some basic parameters for setting the wireless route password.

The SSID number can be filled in with your favorite name or not modified, the purpose of modification is to facilitate distinguishing the frequency band from others' wireless routes when setting wireless devices. When there are multiple wireless routes around the band, you can modify the wireless route password as compared with the others' route band +-3, it is not recommended to use the 13-band because some mobile phones or PDAs with WiFi functions cannot recognize this band ).

Are you sure you want to enable the wireless function? If you have enabled the Security Settings, you are allowed to enable the SSID broadcasting. It is recommended that the beginner players check the security settings to prevent you from forgetting the vrossid SSID and causing unnecessary troubles.) set the wireless route password, in general, select "WEP" for the home network security type, and select "automatically select" for the security option ".

Key format Selection: "ASCII code" in hexadecimal format is troublesome and it is difficult to remember the password). We recommend that you set a 128-bit key type after key 1 ), enter your password in the box corresponding to the key content. Note that the number of characters cannot be large or small.

If you select a 64-bit key, you must enter 10 hexadecimal numbers or 5 ASCII characters. To select a 128-bit key, you must enter 26 hexadecimal numbers or 13 ASCII characters. To select a 152-bit key, you must enter 32 hexadecimal numbers or 16 ASCII characters.

Click "save" to complete the preceding settings. The settings on the computer end are basically the same as those without a password. You only need to enter the corresponding value when you are prompted to enter the SSID number and the English version of the password.

Set the wireless route password. Note: When the setting is complete but the Internet access fails, use the network cable to connect the wireless network card to the local wired network card. Otherwise, the IP address may conflict. Simply put, the network cable is unplugged when wireless Internet access is used. When the network cable is used to access the Internet, use the shortcut key to close the wireless device.