Getting started with cainiao: getting started with wireless LAN Settings

Wireless LAN is not very mysterious, and its parameter settings are largely similar to previous settings. This article will detail the specific operations on wireless LAN Settings, this article takes the XP system as an example to give a detailed introduction.

Preparations

Before setting network parameters, you should correctly install the wireless network card on each computer that requires information transmission, and adjust the distance between the computer and the computer, and place the location of the computer to avoid affecting normal signal transmission. Then, configure the network parameters as follows.

In Windows XP

In comparison, setting wireless network parameters in Windows XP is easier. After all, Windows XP provides users with good support for wireless networks, you can directly set network parameters in the "Network Connection" window, without the need to install additional wireless network management and configuration software. The following describes how to set parameters:

1. on the Windows XP system desktop, click "start", "set", and "Control Panel" commands to open the control panel window, and double-click the Network icon, open the "Network Connection" interface;

2. on this page, right-click the "wireless network connection" icon and execute the "properties" command from the shortcut menu that will be opened later, in this way, the "Wireless Network Connection Properties" Setting dialog box is automatically displayed;

3. Here, you can select the "wireless network configuration" tab with the mouse, and on the tab page that will pop up later, select "use Windows to configure my wireless network configuration" with the mouse to enable automatic wireless network configuration;

4. Click the "advanced" button to open the "advanced" Setting dialog box, and select the "computer-only to computer-specific" option in the dialog box, in this way, computers are connected to each other;

5. If you want to connect directly to your computer and retain the access point, you can use the mouse to select "any available network preferred access point;

6. If a network is available in the preferred access point wireless network, the system will first try to connect to the access point wireless network. If the Access Point Network in the current system is unavailable, then the system will automatically try to connect to the peer-to-peer wireless network;

7. For example, when a laptop is used in a wireless network at work and then moved to another computer for use in a computer network, the automatic wireless network configuration function will automatically change the wireless network parameter settings as needed. You can directly connect to the home network without any changes;

8. After completing the preceding settings, click the "close" button to exit the settings page and click "OK" to complete the wireless connection setting for the wireless LAN, if the parameter is set correctly, the system will automatically prompt that the wireless network connection is successful.