How to appear _ Single ground voltage

1. An example:

Wenzhou Tune-Up-Network View--Plaza--system diagram--square nine Mountain system diagram. svg

1.1. Set on "Data section":

Square _ Nine Mountain system diagram. SVG---in the "HWG3113A Ring network Cabinet" on the bus bar on the ground card: Right-click on the bus ==> set the single-phase ground (V), and then on the single-phase land card right click on the ==> property (you can see here "fault device" above the information shown above is " HWG3113A Ring Network Cabinet. I segment bus bar \ Busbar equipment ") ==>" set nine Hill to 10kVI section bus voltage "Uab/ua/ub/uc/3uo respectively for 1/2/3/4/5 (here is to test the random);" Fault occurrence time "set 2s.

Then, save the Data section--and exit the data section

1.2. Create an anti-accident drill (simulation training)--New training--Select the data section we edited above--open and start training--2s will trigger a malfunction later--double-click on the square nine Mountain system diagram. svg "Hunan 9 31-Wire "switch, jump to" nine mountain change. "The 10kVI section bus of" Fac.svg "found a tabular graph of the single ground voltage appearing next to the bus bar

2.

3.

4.

5.

How to appear _ Single ground voltage