How to crack the Wi-Fi password? Wireless password cracking method tutorial

Step 1: the required equipment for cracking:Computers with wireless NICs (wireless NICS must be compatible with BT3), one USB flash drive larger than 2 GB, one BT3, and spoonwep2 cracking software.

Note: BT3 is a linux system integrated with some computer security software. Spoonwep2 is a powerful tool for cracking WEP wireless network passwords in graphs.

Step 2: install software BT3

1: format the USB flash drive and select FAT32 as the file system.

2: decompress BT3 and copy it to the USB flash drive. After that, two folders, one boot and the other BT3, are displayed in the directory of the USB flash drive.

3: install the BT3 system. Click Start-run and enter CMD to enter the command line mode. First, enter the drive letter of your USB flash drive. Enter cd boot and press enter to enter the boot folder. Finally, press enter to start bt3 installation.

4: then the installation will display a prompt. Let's leave it alone and press any key to continue.

5: The Boot Record is automatically set on the computer. The entire process takes about 10 seconds. After the following figure is displayed, the USB flash drive can guide the system into bt3.

Step 3: integrate spoonwep2 software

First open the spoonwep2 file, which contains six files with the lzm extension, all copied to the t3modules folder of the U disk. (In this way, our bt3 system has been integrated and installed, and you can crack it)

Step 4: start cracking

1: Insert the USB flash drive installed in the system into the computer, restart the computer, and enter the bios. Set the USB flash drive to the first boot.

2: After the configuration is complete, the computer will automatically enter the bt3 operating system (if the interface is displayed, select vesa mode ).

3: Start spoonwep2.

A. Choose start-backtrack-> radio network analysis-> 80211-> all-> spoonwep2, which is the same as that in windows.

After spoonwep2 is started, the NIC information setting window is displayed. You need to set the local Nic interface, Wireless NIC chip type, and scan mode in sequence. After the selection, click next to continue.

B. Click NEXT to enter the scan window. Click LAUNCH in the upper-right corner to start scanning, and then click this button to stop scanning.

C. the software will automatically scan the surrounding wireless network. During the scanning process, information about the wireless network found, transmission speed, intercepted communication packet size, and the used wireless signal frequency end will be automatically listed, encryption type.

4: After scanning for a while, there are almost several signals. Select "bingo" and click "bingo". A white shadow is displayed, and click "selection OK.

5: wait for the password to appear. Return to the windows system and use the password you just obtained to connect to wifi.