Install Win7 system prompts "Unable to update startup configuration" Fault reason analysis and solution

Installing the win7 system prompts windows not to update the startup configuration of the computer, the installation cannot continue, causing the Win7 system installation to fail, and the specific problem is shown in the following illustration:

Failure Reason analysis:

This problem may be caused by a master boot record, so the fix method is primarily to fix the master boot record.

Workaround:

1, the front of the 200M plate deleted, and to C disk. Format C disk. Repair the partition table. Rebuild the master boot record (MBR);

2, again Ghost system to C disk;

3, or because your boot disk is not pulled down, the computer from the startup disk to jump to the hard drive to boot, the solution: After copying files, restart the installation in time to remove the boot disk or set up for the hard drive to start.

The above is the installation of the Win7 system prompts "Unable to update the start configuration" reason and solution to all the contents of the introduction, set up after the successful installation of the Win7 system!