Lab-ccna Configure per-interface Inter-vlan routng

topology

Addressing Table

Device	Interface	IP Address	Subnet Mask	Dfault Gateway
R1	g0/0	192.168.20.1	255.255.255.0	N/A
	G0/1	192.168.10.1	255.255.255.0	N/A
S1	VLAN010	192.168.10.11	255.255.255.0	192.168.10.1
S2	VLAN10	192.168.10.12	255.255.255.0	192.168.10.1
Pc-a	Nic	192.168.10.3	255.255.255.0	192.168.10.1
Pc-b	Nic	192.168.20.3	255.255.255.0	192.168.20.1

Objectives:

Part 1:build the Network and Configure Basic Device Settings

Part 2:configure switches with VLAN and trunking

Part 3:verify Trunking, VLANs, Routing, and Connectivity

Background/scenario

Legacy Inter-vlan routing is seldom used in today's networks; However, it is helpful to configure and understand this type of routing before moving on to Router-on-stick (trunk-based) in Ter-vlan routing or configuring Layer-3 switching. One of the benefits of Legacy Inter-vlan routing is ease of the configuration.

Part 1:build the Network and Configure Basic Device Settings

Step 1:cable the network as shown in the topology.

Step 2:initialize and reload the router and switches.

Step 3:configure Basic Settings for R1.

1. Disable DNS Lookup
2. Assign the device name.
3. Assign the class as the privileged EXEC mode encrypted password.
4. Assign The Cisco as the console and Vty line password and enable login.
5. Configure addressing and enable both interfaces.

Step 4:configure Basic settings on S1 and S2.

1. Disable DNS Lookup
2. Assign the device name.
3. Assign class as the privileged EXEC mode encrypted password.
4. Assign Cisco as the console and Vty line password and enable login.

Step 5:configure Basic settings on pc-a and Pc-b.

Part 2:configure switches with VLAN and trunking

Step 1:configure VLANs on S1.

1. On S1, create VLAN 10. Assign Student as the VLAN name.
2. Create VLAN 20. Assign Faculty-admin as the VLAN name.
3. Configure F0/1 as the trunk port.
4. Assign ports F0/5 and F0/6 to VLAN Ten and configure both F0/5 and F0/6 as access ports.
5. Assign an IP address to VLAN Ten and enable it. Refer to the addressing Table.
6. Configure the default gateway according to the addressing Table.

Configure VLANs on S2.

1. On S2, create VLAN 10. Assign Student as the VLAN name.
2. Create VLAN 20. Assign Faculty-admin as the VLAN name.
3. Configure F0/1 as a trunk port.
4. Assign ports F0/11 and F0/18 to VLAN and configure both F0/11 and F0/18 as access ports.
5. Assign an IP address to VLAN Ten and enable it. Refer to the addressing Table.
6. Configure the default gateway according to the addressing Table.

Part 3:verify trunking, VLANs, Routing, and Connectivity

Show IP route

Show interface Trunk

Show VLAN Brief

Ping

Lab-ccna Configure per-interface Inter-vlan routng