Linux View network Bandwidth __linux

First, nload

Device eth0 [10.16.169.14] (1/2):
====================================================================
Incoming:
                                          curr:27.99 kbit/s
                                          avg:33.14 kbit/s
                                          min:19.02
                                          kbit/s
                                          max:116.44 kbit/s ttl:74.46
Outgoing:
                                          curr:20.26 kbit/s
                                          avg:83.46 kbit/s
                                          min:17.72 kbit/s
                                          max:3.19 mbit/s
                                          ttl:145.30 gbyte

Incoming is to enter the network card traffic, outgoing, that is, from the network card out of the traffic, each part has the following several. Curr: Current flow avg: Average traffic min: min flow max: Maximum flow Ttl: Total traffic

1, nload default is the Eth0 network card, if you want to monitor the flow of ETH1 network card, you can use the following command.

Nload eth1

2, at the same time to view the flow of multiple network cards

NLOAD-M//results are as follows: Device eth0 [10.16.169.14] (1/2): ================================================================== ====================== incoming:outgoing:curr:30.23 kbit/s C                           urr:28.14 kbit/s avg:32.80 kbit/s avg:69.48 kbit/s min:23.65 kbit/s                            min:18.23 kbit/s max:133.16 kbit/s max:3.17 mbit/s ttl:74.46 gbyte ttl:145.30 gbyte Device Lo [127.0.0.1] (2/2): ======================================================================  ================== incoming:outgoing:curr:0.00 bit/s Curr: 0.00 bit/s avg:150.82 kbit/s avg:150.82 kbit/s, min:0.00 Min  : 0.00 bit/s max:7.51 mbit/s max:7.51 mbit/s ttl:276.67 Ttl: 276.67 GByte