We will give you a detailed analysis of the post-processing tutorial on bringing up small fresh portraits and photos to users of photoshop software.
Tutorial sharing:
SOURCE image:
We first adjust the light and layers through the basic adjustments in the ACR switch,
Appropriate highlight and white make the layers of the photos richer, and adjust them with shadows and black colors,
Add some natural saturation to let the film's green and men's trousers and the blue of the prop boat jump out. The data is as follows:
Next, the camera calibrated the blue primary color and saturated color to make the entire film more transparent,
The original green phase + 9 is used to make the skin smooth, and reduce the saturation so that the film's Green will not jump so far.
Next, HSL/Grayscale. This tool is very precise for the color division in the photo. You can modify a color in a single channel. Remember to only use the color in the animation,
If there is no color, do not change it. You can intuitively see that the screen contains green, blue, yellow, orange, and a small amount of red. Then we adjust these colors, color the yellow color to green,
Make the color of the grass and small trees in the screen uniform, yellow and blue, green saturation brightness make appropriate adjustments. As shown in the following figure:
Comparison before and after transfer
To put it bluntly, the shift is to restore the color, and the data is not important, depending on the film.
After opening the image, I will not talk much about skin repair. I use high and low frequencies.
Go to PS
The first step is to use the gradient ING to select black and white as the gray-removing mode. The brightness of the hybrid mode reduces the transparency to 20-30.
Mask: use an optional color to adjust the yellow and red colors of the skin color to make the skin more transparent.
Highlight and dark parts are selected to highlight the highlights, and the dark parts are pressed to make a comparison between the film layers.
Optional color Single Channel white, add blue and blue to the sky and water in the screen
Use the color saturation to add saturation to the green and blue channels, so that the two most fresh colors in the screen can jump out.
The level layer adds a color to the highlights and the dark parts respectively. My options are highlight + a little red to make the skin more red, and the dark part + a little blue to make the film clean.
Curve tool, red channel dark part minus a little red
The curve is pressed to create a mask. You only need to press the ground to hide the gradient.
Now it's basically done here. You can see that the picture is lit up in the sky, and men's shoulder and clothes are a bit explosive,
Finally, we will teach you how to fill in the color and select Cyan. The mixed mode is changed to exclude, and the opacity is changed to 5,
This step is also critical. It can neutralize the gray scale of the highlight and darkness, and make a transition between high light and darkness for the film,
The comparison diagram is as follows:
We can see that the figure below is filled with color. The highlights of the sky and the dark areas in the grass and small trees below reach the neutralization, and there is a little gray feeling at the same time, the color in the screen has been unified and softened a lot.
Final effect!
<Click a picture to see the big picture> www.16xx8.com
Appreciation of other works:
All right, the above information is all the content that I have shared with the users of this software of photoshop in detail by calling up the tutorials for post-processing of small fresh portraits and photos, you can see the software users here. I believe that you are very clear about the post-processing tutorial, so all the software users will go and follow the tutorial above to bring up small fresh portraits and photos by themselves.
