PS Filter for beach wedding photos to change the background

Pick the wedding is more troublesome, with a single pull tool to pull out the effect is not very ideal, because the transparent wedding dress into the background, if the background is messy, the wedding dress has a lot of sundries. Later on, it takes time to clean up the wedding dress slowly.

Final effect

Original

First, open the material picture, create hue/saturation adjustment layer, choose red, with a straw to absorb the sand beach color adjustment, the background red point, parameters and effect of the following figure. This step to the background and wedding color contrast, easy to pull behind the drawing.

Second, create a new layer, press CTRL + ALT + Shift + E-stamped layer, as shown below.

Third, enter the channel panel, you can observe the red, green, blue channel, choose the wedding details of a better channel (background color is red, green channel is naturally the best channel). Copy the green channel and then operate on the copied channel.

Four, press CTRL + L adjust the color level, parameter settings such as Figure 5, you need to adjust the input and output levels, the effect is as shown in Figure 6. This step lightens the highlight slightly, turning the dark part to Gray. This picture is relatively clean.

Five, press CTRL + A SELECT, press CTRL + C copy, point RGB channel to return to the layers board, create a new layer, press CTRL + V paste, the effect of the following figure. The background is gray, using the channel to pull the map is not very good, with the extraction is the most ideal.

Six, the right side of the wedding dress more, with the Lasso tool to select this part, the selection feather after the curve slightly darkened, the following figure.

VII. implementation: Filter > Extract (without the need for this filter to download the installation separately), the white part of the painting, and then on the right side of the Setup Panel to check the forced foreground color, select white, and then determine.

Eight, under the current layer of a new layer, fill any color, you can see the effect of the pull out, the wedding part of the details to maintain a better, and also relatively clean.

Add a layer mask to the current layer, select the Brush tool, set the foreground color to black, and paint some of the miscellaneous points in the middle with a brush, these are the lighter sand grains.

Ten, painted after the effect of the following figure, a few miscellaneous points, but the details of the wedding dress is lost, the back need to manually recover.

Create a new layer below the current layer, select the Brush tool, set the opacity to 10%, and the foreground color to white. Then use the brush to paint the part that needs more detail, as shown below.

12, the background layer to copy a layer, press CTRL + Shift +] top, with a pen to pull out the characters, the effect of the following figure.

13, create optional color adjustment layer, red, yellow to adjust, fine-tuning the character skin tone, parameters and effects of the following figure.

Finally, deal with the details, plus your favorite background, complete the final effect.

Category:

• PS Filter Tutorial
• PS Wedding Photo Processing tutorial