Step by step teach you how to set a password for a wireless route

I used wireless route to access the Internet, but recently I found that the network speed was very slow. I checked my network neighbors and found someone sharing my wireless network. I heard that a password can be set for the wireless network, but I don't know how to do it, please advise! This article uses TP-Link Wireless routing as an example. Other Wireless routing passwords are set similarly, and some wireless routers set their passwords: the router address and access password are only provided by default. Please replace the value set by yourself ).

◆ Open the browser, enter 192.168.1.1 in the address bar, and press enter to bring up the wireless route settings password prompt window.

◆ In the password prompt window, enter the user name and wireless route settings. The password is admin by default. If there is any discrepancy, the corresponding value should be given below the vro) and press OK. The setting wizard is displayed and the setting page is displayed. You can close the setting wizard and enter the specific Wireless Settings section.

◆ Click "Wireless Parameters" in the left-side list to go to the "Wireless Network Basic settings" page.

◆ On the right page, you can see some basic parameters for setting passwords for wireless routes.

The SSID number can be filled in with your favorite name or not modified, the purpose of modification is to facilitate the differentiation of the frequency band with other people's wireless routes when setting wireless devices. When there are multiple wireless routes around the band, the change is generally compared with the others' route band +-3 to set the password for the wireless route, it is not recommended to use the 13-band because some mobile phones or PDAs with WiFi functions cannot recognize this band ).

Are you sure you want to enable the wireless function? If you have enabled the Security Settings, you are allowed to enable the SSID broadcasting. It is recommended that the beginner players check the security settings to prevent you from having forgotten the vrossid SSID and causing unnecessary troubles, in general, select "WEP" for the home network security type, and select "automatically select" for the security option ".

Key format Selection: "ASCII code" in hexadecimal format is troublesome and it is difficult to remember the password). We recommend that you set a 128-bit key type after key 1 ), enter your password in the box corresponding to the key content. Note that the number of characters cannot be large or small.

If you select a 64-bit key, you must enter 10 hexadecimal numbers or 5 ASCII characters. To select a 128-bit key, you must enter 26 hexadecimal numbers or 13 ASCII characters. To select a 152-bit key, you must enter 32 hexadecimal numbers or 16 ASCII characters.

Click "save" to complete the preceding settings. The settings on the computer end are basically the same as those without a password. You only need to enter the corresponding value when you are prompted to enter the SSID number and the English version of the password.

Wireless route settings password Note: When the configuration is complete but cannot access the Internet, please use the network cable to connect to the Internet wireless network card and local wired network card cannot be enabled at the same time or it may cause IP address conflict. Simply put, the network cable is unplugged when wireless Internet access is used. When the network cable is used to access the Internet, use the shortcut key to close the wireless device.