Thunderbolt 8 high-speed channel speed of 0 no speed solution

Warm tips

This article applies to high-speed channel "no speed", "speed is not obvious", "accelerated Slow", "Service paused" type.

has entered the high speed Channel-but not speed.

The following figure shows the problem, the hint has entered the high-speed channel and later accelerated to 0kb/s, such as not to show "entered the high-speed channel", please skip the exclusion of "1", go directly to "2".

Access to high speed Channel-not noticeable

1, here speed display 113kb/s, the following high-speed channel also has accelerated, if the current use of bandwidth is 1m, then this speed is normal, 1m bandwidth download speed of the highest 100kb/s about.

2, high-speed channel can only play the role of acceleration to speed up to the bandwidth limit speed, theoretically, as long as there is 40m bandwidth support can be accelerated to 4m/s.

High-speed channel-slow speed

1, to see whether the network speed Limited. For example, whether to open the smart Internet, speed protection, but also need to eliminate anti-virus software, firewalls.

(such as the activation of the exit attempt can, generally in the computer's right to find anti-virus software, such as security software, right click to exit Can)

2, if it is not exclusive network (exclusive network: A net cable of their own use, not through the router points of the network), such as Campus network, corporate network, community network, can consult the students around or whether the normal use of friends. If the colleagues and friends are not normal use, that the current network must exist on the thunderbolt restrictions or anomalies, it is recommended to consult the internal network administrator and provide network services operators whether the Thunderbolt or Peer-to-peer agreement to make restrictions, blocked. "High speed access is through Peer-to-peer protocol for accelerated download"

3, if the above is invalid, then download the tool to check the speed of Peer-to-peer protocol how much.

"Speed tool Download link Address": Http://pstatic.xunlei.com/tool/tool-speed-12ed.rar

Close antivirus software and firewalls, there are, thunder other programs (QQ can not turn off), and then unpack, open the "Tool.exe" program.

4, click the bottom right "ban detection"

5, in a pop-up box click the following four buttons to test

"1" Command detection = "Flow query submission =" Speed contrast = "multi-resource Peer-to-peer speed measurement

"2" After the speed measurement, the following figure: (mainly to see how the Peer-to-peer protocol speed, because high-speed channel is through this protocol to accelerate.) )

"3" shows little or no direct 0, as shown below, and is "caused by current network limitations or blocked peer-to-peer situations."

Solving method

If you have ruled out anti-virus software, traffic monitoring and other security software restrictions, "Please contact the network operator or network administrator."

High-speed Channel – service paused

As shown in the following illustration, "High-speed Channel service paused", the task indicates that the task is waiting or paused;

It is because the task that did not start the download is not accelerated.

Solving method

1, Thunderbolt 7 = "System settings =" My download = "Common settings =" task management = "Run the maximum number of tasks at the same time is set to 1.

2, the following figure, check whether there is "Enable sequential download" function. The "Sequential download" feature starts with a check in front.

(Enable state diagram)

3. The following illustration prompts "accelerated end" because some of the resources currently downloaded are temporarily unsupported by acceleration. This occurs because not all resources support acceleration, and some of the BT resources have multiple child files.

"Note: Child files that do not support acceleration do not deduct high-speed channel traffic"