Uefi failed to boot installation system when installing system hint GPT

Method One:

The first step is to refer to the following. Mainly for the format of the disk, the system format into the MBR

Using the system disk to boot to the installation interface, to the partition of the block by pressing SHIFT+F10 followed by the following operations, complete GPT conversion to MBR format

〉diskpart

>list disk

>select disk X (the disk you want to convert, the list disk above can be listed, as follows)

〉clean Clear all the information (overall format, so pay attention to OH)

〉convert MBR (or GPT) (choose MBR or GPT as desired)

More Wonderful content: http://www.bianceng.cnhttp://www.bianceng.cn/OS/skills/

The second step, install the above operation, after refreshing or not install will prompt "This computer's hardware may not support the installation boot to this hard disk, please ensure that the BIOS menu has the hard drive controller." ”

Method Two:

Use the WinPE to enter the following actions with the Diskgenius tool

This problem, tip point to the BIOS setup hard disk controller, in fact, it is not the case, you should use the Disk tool software to the installation of the system's hard disk primary partition repartition operation, before installing the 7 system with the disk tool software Delete the primary partition, and then create a new primary partition, and format, the format of the  and activate this primary partition, when this primary partition has no data, is the primary partition, is the active partition, is the NTFS format, this conforms to the WIN7 system requirements. Re-build the master boot MBR and install it.

This article is from the "Flying Pig" blog, please be sure to keep this source http://thinkpig007.blog.51cto.com/971471/1252233