Thanks to the laptop connected to the router, so toss it up for a while, I'll go no matter how it's configured well anyway
There are a few problems here. A small count, from the beginning
First hardware to ensure the switch to open the infinite network card, such as my is the FN+F3 key
Then perform the following:
Iwconfig Wlan0 Txpower on
The first is to ensure that there is a NIC driver
[Email protected] ~]# Iwconfig
Lo no wireless extensions.
Eth0 no wireless extensions.
Wlan0 IEEE 802.11bgn ESSID: "LiebaoFree979"
mode:managed frequency:2.437 GHz Access point:08:57:00:61:cd:e4
Bit rate=1 MB/s tx-power=20 dBm
RTS Thr:off Fragment Thr:off
Encryption Key:off
Power Management:off
Link quality=70/70 Signal level=-31 dBm
Rx Invalid nwid:0 Rx Invalid crypt:0 Rx Invalid frag:0
Tx Excessive retries:0 Invalid misc:0 Missed beacon:0
Sit0 no wireless extensions.
The top is there, if all is no wireless ... This sign, I want to tragedy, I have to install the driver alone, fortunately, my top is not, hey
There is a driver, the next is to configure the problem.
First set up a configuration file as follows
[Email protected] ~]# more/etc/network/wlan0_conf
Ctrl_interface=/etc/network/wpa_supplicant
Ctrl_interface_group=wheel
Update_config=0
network={
Ssid= "LiebaoFree979"
Proto=wpa
Key_mgmt=wpa-psk
psk= "Sb123123"
}
Where PSK is the password, SSID is the name of my WiFi
Execute the following command
[Email protected] ~]# wpa_supplicant-d-dwext-iwlan0-c/etc/network/wlan0_conf
Next, we'll run a whole bunch of information.
[[email protected] ~]# Ping www.baidu.com
Connect:network is unreachable
[Email protected] ~]# service network restart
Shutting down interface wlan0: [OK]
Close Loopback interface: [OK]
Eject loopback interface: [OK]
Popup interface eth0:
Determining IP information for eth0 ... Failed; no link. Check the cable?
Failed
[Email protected] ~]# ifup wlan0
Determining IP information for wlan0 ... Complete.
[[email protected] ~]# Ping www.baidu.com
PING www.a.shifen.com (61.135.169.125) bytes of data.
Bytes from 61.135.169.125:icmp_seq=1 ttl=57 time=11.8 ms
Bytes from 61.135.169.125:icmp_seq=9 ttl=57 time=4.91 ms
Bytes from 61.135.169.125:icmp_seq=10 ttl=57 time=218 ms
Bytes from 61.135.169.125:icmp_seq=11 ttl=57 time=5.03 ms
---www.a.shifen.com ping statistics---
Packets transmitted, 4 received, 63% packet loss, time 10000ms
RTT Min/avg/max/mdev = 4.914/60.022/218.329/91.441 ms
See here is basically OK pull, haha, habitual look at the IP, as follows Wlan0
[Email protected] ~]# ifconfig
Lo Link encap:local Loopback
inet addr:127.0.0.1 mask:255.0.0.0
Inet6 addr::: 1/128 scope:host
Up LOOPBACK RUNNING mtu:16436 metric:1
RX packets:2065 errors:0 dropped:0 overruns:0 frame:0
TX packets:2065 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:0
RX bytes:2564655 (2.4 MiB) TX bytes:2564655 (2.4 MiB)
Wlan0 Link encap:ethernet HWaddr ec:55:f9:7a:bc:7f
inet addr:20.20.0.111 bcast:20.20.255.255 mask:255.255.0.0
Inet6 ADDR:FE80::EE55:F9FF:FE7A:BC7F/64 Scope:link
Up broadcast RUNNING multicast mtu:1500 metric:1
RX packets:6628 errors:0 dropped:0 overruns:0 frame:0
TX packets:6917 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:5493110 (5.2 MiB) TX bytes:1017924 (994.0 KiB)
Well, in the middle of the configuration, the network attributes of the wrong, the start prompt network is unreanable, there is a hint of the net error 132 and so on
Well, basically the whole toss-up process is so, I hope to help the classmate and I use the Notebook ~ ~ ~
CentOS System notebook Wireless card connection WiFi note
