Hard Disk installation centos 5.1

After a few days, centos found that it was very useful, so I installed a computer at home.
Files used:
CentOS-5.1-i386-bin-DVD.iso
Dwarf dos toolkit 4.1 // use grub 4.1, 4.2 With grub, 5.0 without grub
Initrd. IMG // can be extracted from ISO. I copied it directly.
Vmlinuz // same as above

My system
Two hard disks. the front end of the hard disk 0 is empty for more than 60 GB, and the remaining two NTFS Disks
Hard Disk 1 has 7 disks, drive C is WINXP, and drive I in 7th partitions is FAT32, and the rest are in NTFS format.

Install the dwarf dos toolbox and add the following content in C:/boot/GRUB/menu. lst (replace directly)

Title centos setup
Root (hd0, 0)
Kernerl/vmlinuz
Initrd/initrd. img
Boot

Put ISO in the root directory of the FAT32 disk (disk I), and put the rest in the root directory of the C drive.

 

Restart, select dwarf DOS, and then select centos setup
Then go to the Blue simple installation screen and select Simplified Chinese, prompting you to temporarily not support anything,
Then select the default keyboard
Then select! Hard Disk installation !,
Then select the hard disk installation source, and my I disk is counted as sdb10 in Linux (you can press the hard disk one by one if you do not know it). If you fail to press the wrong one, you will always press --)
Then the system starts to load the video card into the installation interface of the Chinese image.

In the graphic interface, you must note that only primary partitions can be created when partitioning ??
So if you create/boot swap/home and then create/again, a problem will occur.
I quit here and use pqmagic to get the two partitions into the logical partition and try again.
In addition, when I installed grub, I chose the first partition on the Linux hard disk.
As a result, Debian was installed before, and busybox was directly installed.
Later, the grub was installed in MBR only after the grub was installed.

Attached