Install centos 7.2

I learned some front-end knowledge and didn't have time to share it with you. Now I will share the detailed instructions on installing the server operating system. Thank you for your attention.
The image burning process will be shared with you later. The installation process will be explained in detail today.

Install the Operating System

The following uses a USB flash drive to install centos 7.2. If you use other methods for installation, the first step is different.
Step 2: Set the USB flash drive as the Boot Mode
Plug in the USB flash drive and start the server. Press F7 on the startup screen (the machine is different from each other) to go to the settings page and select the USB flash drive:
Note: At present, the data disk is not separated from the system disk, and the disk space is greater than 2 TB. You need to select the boot mode as UEFI boot. You cannot use legacy to start the disk.

Step 2: Start to install centos7 (if you use this USB flash drive for the first time, we recommend that you run test before installation)

If problems occur during installation here:/dev/root not exist, refer to: http://blog.51cto.com/13363488/2308002
Step 2: select the language of Installation
Select English. Click "continue" in the lower right corner:

Step 2: select the system time

To locate problems and view logs in the future, we recommend that you configure the local time of the system as follows:
Select Date & time ":

Select "Asia" for Region and "Shanghai" for city. After the configuration is complete, click "done" in the upper left corner to complete the Configuration:

Step 2: select the software installation type
Select "software selection ":

Select "infrastructure server". You do not need to select either of the following options on the right:

Step 2: select the software installation location
Select "installation destination ":

Select a hard disk and manually split the disk. Then, select "done" in the upper left corner ":

Go to the custom partition page, and click "-" in the lower-left corner to clear the current partition:

After clearing the partition, click "+" to add a new partition. Make sure that most of the space is placed under "/" ("/" is required by the system, so try to allocate space to "/"):

After configuration, click "done" in the upper left corner:

Step 2: Click begin installation in the lower right corner to start installation.

Step 2: Set the root user password
Select "Root Password ":

After the setup is complete, please wait patiently for the installation process:

Step 2: restart your computer after installation.

Install centos 7.2