Simulate incoming calls on the android Simulator

Recently, the project needs to implement a call display control function.Android
Application

On emulatorAnalog call
Effect

The method is as follows:

1. Single phone number

 

Open command line cmd, enter Telnet and press Enter.

Enter o localhost 5554 and press enter to connect to emulator.

Enter GSM call 123456 and the above shows OK

Then I went to the simulator and there was a call on it.

Others:
Hanging up the phone number: GSM cancel <analog phone number>
Set other modes: GSM voice unregistered cannot connect to the network, and denied is the emergency call mode.

Reference: http://www.my400800.cn
)
Help GSM
Allows you to change GSM-related settings, or to make a new inbound phone call

Available sub-commands:
GSM list current phone CILS
GSM call create inbound phone call
GSM busy close waiting outbound call as busy
GSM hold change the state of an oubtound call to 'held'
GSM accept change the state of an outbound call to 'active'
GSM cancel disconnect an inbound or outbound phone call
GSM data modify data connection state
GSM voice modify voice connection state
GSM Status display GSM status

2. Simulate multiple phone calls from multiple Simulators


Start Multiple simulators and play the port number of simulator B in simulator.

3. send SMS


SMS send <phone number used to send a simulated text message> <SMS content>
Example: SMS send 1234567 hello

 

 

 

Vista
Used in the system

Telnet Service
Device Problems

 

[Q] in Vista, enter telnet, and the system prompts that the file cannot be found. How can I retrieve Telnet.

[Answer] Many do not find Telnet in VistaProgramFor example, if you enter Telnet in the "Start" "Run" or "Search" box, the system prompts that the file is not found. In fact, Vista is not installed by default, because it is set for the server, windows Server 2008 is installed by default.

The solution is also very simple. Install the system components of Vista directly. The procedure is "My Computer"-> "Control Panel"-> "program and function, tree map on the left
You can see "enable or disable the WINDOWS function". In the new dialog box "WINDOWS function", you can see
Select "Telnet Server" and "Telnet client", and then telnet is restored. If it is only used to connect to a remote server, we only need to install "Telnet client"
End.