First, install Centos6.5 (64-bit) steps in VMwareWorkstation10:Download VMware and centos6.5 first
1. Open vmware-workstation Click "New Virtual Machine" to the wizard window. Select Customize, Next.
2. Select the virtual machine hardware compatibility workstation10.0, next.
3. Select Install the system later, next.
4. Select the operating system for Linux, version CentOS 64-bit. Next.
5. Give the virtual machine a name, specify the installation location, and next.
6. Configure the processor information (I use the default here), next.
7. Configure the memory information (I use the default information here), next.
8. Configure Network information (either bridge or host-only mode is recommended), next.
9. Select the I/O type (default setting), Next.
10. Select the disk type (default), next.
11. Select Create new disk, next.
12. Configure the disk size, next.
13. No changes, next step.
14. Configuration successful, complete.
15. If you need to change the configuration you just made, click Workstation Edit virtual machine settings to make the changes. Here we specify the location of the CentOS image file and tick the link at startup.
16. Click Workstation to turn on this virtual machine. Enter the CentOS installation window. Select the installation system (the first can be the second one), enter.
17. Select Skip, enter.
18. Click Next.
19. Select 中文版 (English is recommended for compatibility issues), next.
20. Select U.S. English, next.
21. Select the basic storage device, next.
22. Select Format data, next.
23. Name hostname, configure the network connection configurenetwork. Select Connect automatically to connect automatically. Next.
24. Select the time zone, next.
25. Set the password for the root user and the next step.
26. Default settings, next.
27. Select Destop, Next.
28. Start the installation and wait for the installation to finish.
29. When the installation is complete, click Restart.
30. Configure the user information, next, complete the restart, the CentOS installation completed.
Create a good user and set the time, so that the Centos installation is complete.
Second, after the installation is complete, found that can not be networked, so in the Internet to find a lot of methods, here list my machine feasible method, other methods there are many did not try.
Note the Red section, 1 ordinary users under the service network restart is not working, please go to the root role, if you can see less than four green OK, you also need to configure
Modify the /etc/sysconfig/network-scprits/eth0 file
The IP value of the broadcast is consistent with the IP in the VMNET8 and the last one must be 255
The IP value of the IPADDR is consistent with the IP in the VMNET8 and the last one must be an arbitrary value of 1~255
The IP value of the Getway is consistent with the IP in the VMNET8 and the last one is 2
eg
My native IP is 192.168.11.1, then the correct configuration is:
broadcast=192.168.11.255
ipaddr=192.168.11.1
getway=192.168.11.2
Note also modified: Onboot=yes
VMware installs CentOS 6.5 graphics and text steps and solutions that cannot be networked after installation
