Cent6.6, U disk installation, 64-bit normal operation of DrClient

Cent6.6, U disk installation, 64-bit normal operation of DrClient

Previously, Cent6.4 was installed with a USB flash drive. The online tutorials were basically the same and were not repeated. Switch to 6.6, and start with the question.

1. Next. iso file (No problem, I believe you ).

2. Use UltraISO to directly burn a USB flash disk. It is relatively simple. Start --> write a hard disk image --> another pop-up box is displayed. There is a boot mode on the right, HDD +. Don't forget to select a USB flash disk. (No problem, preparation is OK ).

3. Change the Boot Mode to USB flash drive and install Cent directly. You can refer to the online tutorial for more instructions.

4. to put your DrClient in the system, you need to install the 32-bit Runtime Library. You need to configure it with an ip address. After the ip address is configured, run the command $ sudo yum install xulrunner. i686. The installation is complete. Congratulations, you are about to succeed. Then run privillege. sh, it is recommended to run on the terminal, sh privillege. sh.

5. Check whether DrClientLinux runs successfully.

6. If the firewall fails, shut down the firewall and try again. service iptables stop

Success.