After we have designed the process, often have to pass the test, the whole process, but a process to multi-person approval to go through, so change someone else's account to test the process is very troublesome.
So we designed a debug mode that allows you to see information when the process is running (error messages are displayed when the error occurs), and to use an account to complete the process.
Turn on debug mode
Open Process Designer and then open the process you want to debug--open debug mode in Properties
OFF: The debug mode is turned off.
On (with Debug window): This way, when the process runs, there is a debug window to display the process submission information, and if there is an error, an error is displayed in the window.
On (No debug window): The Debug Information window is not displayed.
The following selection of debuggers: That is, the debug mode for which people, in addition to the selection of people outside the process of running processes, or flow according to the process set.
After opening the effect is as follows:
. NET open source Workflow roadflow-process run-debug