CentOS5.1 on TM4520

CentOS5.1 on TM4520-Linux Enterprise Application-Linux server application information. For details, refer to the following section. During the weekend, I was always looking for something to do. I haven't installed linux on my laptop. I installed Ubuntu 8.04 Server last night. Unfortunately, it was in CLI mode. I used apt-get install gnome, no response. I started to think that Ubuntu is not easy to use, but I didn't find out until CentOS was installed. This is not a system problem. It is a problem with a local computer and cannot access the Internet, how can we blame apt-get?

This morning, CentOS 5.1 is installed and cannot be installed on the graphic interface. After the installation, you can only go to CLI mode. It is really depressing. An error is reported after startx. If you suspect that it is a video card problem, restart XP, on the http://ati.amd.com/support/driver.html, so choose: Linux x86_64 -- Intergrated/Motherboard --- Radeon Xpress 1250, then download, switch to Linux, chmod + x ati-driver-installer-8-5-x86.x86_64.run, and then. /ati-driver-installer-8-5-x86.x86_64.run, after installation will prompt wrong, but after startx can enter the GUI normally, it is successful.

The problem is always one by one. The next problem is that the network cannot be connected and the gateway cannot be pinged. As a result, the network card must be faulty. In the network configuration, both devices can be driven. One is Marvell Yukon 88E8071 Gigabit Ethernet Controller and the other is Broadcom configurationbcm94311mcg wlan mini-PCI, but the third is sky2 in the hardware, the attribute is also the Gigabit Ethernet of Marvell. If two connections are deleted from the device and an Ethernet connection is re-built, no matter whether the connected hardware is Marvell or sky2, if you still suspect that the driver is the problem, go to unzip Controoler (in fact, only this one is available). Choose Linux 2.6-Fedora below, click Submit, go to the new page, and download: Lin Ux Driver Install Package for Yukon Devices, download, decompress, and run. /install. sh, then select 1) installation, then answer Y, finally select 2) Deactivate diver, wait a moment to install, in the network there, you can see a more hardware, SysKonnect SK-98XX Gigabit, create an Ethernet connection for the device. Select the device we just installed as the hardware. OK, you can access the Internet.

At first, I was worried that many hardware drivers in my notebook could not be used. At least it was identified by a card reader in my notebook. After waiting for a while, find out if I can use the wireless network card. Recently I want to know about Linux Cluster. So I want to do this. I installed two CentOS instances in the virtual machine. I don't know how to do this, if you want to use two physical machines, it seems that there must be two connections at most. Apart from the existing connections, the second connection is to use a wireless network card to connect to the desktop.

The desktop display is broken, and now it is remotely connected. Haha, it's not a general headache.