cisco2960 upgrading iOS and updating configurations

1. Configure the IP address to upload IOS and config.text files

Switch#conf T

Switch (config) #int vlan 1

Switch (config) #ip add 172.16.1.1 255.255.0.0

Switch (config) #no shut

Switch (config) #end

Switch#ping 172.16.1.2// computer configured IP, to and above the address in a network segment

Ping Pass after the network is no problem, you can upload IOS and configuration Files

plug the network cable into any port of the switch, as the default is in vlan1

2. uploading IOS and configuration Files

Switch#copy Tftp:flash:

prompt to enter remote host 172.16.1.2

prompt to enter the file name to be passed (note the suffix)c2960-lanbasek9-mz.122-50.se5.bin

prompt for destination filename c2960-lanbasek9-mz.122-50.se5.bin

transfer started, same as in the config.text file upload

3. Modify the boot image

Switch#config T

Switch (config) #boot system Flash:c2960-lanbasek9-mz.122-50.se5.bin

Switch (config) #end

Switch#wr

Switch#reload

Reboot to see if New IOS is started ,show version

after confirming,copy Flash:config.text system:running-config

Wr Save, upgrade and follow the new configuration, on Ciscows-2960-24tt-l

This article is from the "Network You and Me" blog, please be sure to keep this source http://yzmlinux.blog.51cto.com/4063523/1620399

cisco2960 upgrading iOS and updating configurations