Android Drive Development (v)----build a test environment for the Development Board

In the fourth chapter, the Android application development environment and the Linux kernel development environment are introduced. Both sets of development environments are prerequisites for Linux development and testing. With two sets of development environments, it's a good place to think about where the Linux drivers should run and what the environment is. This is also the fifth chapter of the content.

When a Linux driver that has finished testing is put on a board, the board also has an environment that allows Linux drivers to run, which is where Android is used to meet this requirement.

When you get a development board, you first use a method to transfer data to the Development Board and place the development environment on the Development Board. In the book is the use of SD card, that is, the brush machine said card brush (also can use the serial port or network, etc., if the use of the way, then there will be a serial port driver (because a lot of laptops and no serial port, then you can use the USB to the serial port, the serial cable connection, and connect to the PC) , install a good serial port driver can be written to the Development Board on the system, then the Android_fs.tar mmc.bin zimage copied to the SD card, the SD card into the Development Board, set up the Development Board boot mode to the SD card boot, start burning from SD card system.

Different kinds of development Board to write the system in a similar way, when you get a development board, you should learn from the development of the Board of information on the way the system is written.

Android Drive Development (v)----build a test environment for the Development Board