Android Deep Exploration (Vol. 1) Hal and Driver Development Fifth Chapter summary

Development Board is the development and learning of embedded technology, the main hardware equipment, development Board models and types of many, the current popular is based on the s3c6410 ARM11 Architecture Development Board,s3c6410 is a low-power, cost-effective RISC processor, based on the ARM11 Core, which is widely used in mobile phones and through-demon processing.

OK6410The development Board is based on Samsung's latestARM11Processors3c6410, with strong internal resources and video processing capabilities, can be run stably in667MHZfrequency above, supportmobileddrand a variety ofnandflash.ok6410The board integrates a variety of high-end interfaces, such as composite video signals, cameras,USB,SDcard, LCD screen, Ethernet, and equipped with temperature sensor and infrared receiver first class, usingOK6410development boards can also be used in other ways realityLinuxDriver output debugging information, this is the serial communication. Chapter onminicomserial Debugging tools are described in detail.

First step: Detect whether the current system supports USB to serial port

Step Two: Install minicom

Step Three: Configure minicom

Fourth step: Detect minicom

Before burning the Android system, you need to use eboot to erase the Nandflash, as follows:

The first step: getting Ready for work

Step Two: Enter the eboot State

Step three: Erase Nandflash

The steps to burn Android are as follows:

The first step: getting Ready for work

Step Two: write mmc.bin and ZImage.sb.bin to SD card

Step three: prepare to burn and write before Android

Fourth step: Start burning from SD card to write Android

Fifth step: Calibrate the screen

This chapter is really about installing Androidon the OK6410 board.

http://home.cnblogs.com/u/zivjeli/

Android Deep Exploration (Vol. 1) Hal and Driver Development Fifth Chapter summary