Powervm partitioning and installation system

Powervm partitioning and Installation System 1. use hmc to create a partition configuration file name and allocate memory. Note that vscsi devices must be created in the middle of the maximum number of slots in the cpu. pay attention to the ID number and create a vscsi device corresponding to vios at that time. If you create a network card, you can create it or not. if you create a network card, pay attention to the vlanid. 2. powervm partitioning and Installation System 1. use hmc to create partition configuration file names and allocate memory. Note that vscsi devices should be created in the middle of the maximum number of slots in the cpu. pay attention to the ID number and create a corresponding vios. If you create an Eni, you can create it or not. if you create an Eni, pay attention to the vlan id. 2. check the vios server and client profiles respectively to maintain the corresponding settings. Vios server dynamic logical partition --- physical adapter -- add scsi, which takes effect directly. 3. go to the vios server command line to find the corresponding ID number. vhost is the corresponding clientlsdev-dev vhost *-vpdlsmap-all to view unused hard disks (hdisk is directly allocated here) lspvmkvdev-vdev powerdisk9-vadapter vhost7-dev vhostdevlsdev-dev vhost *-vpdlsmap-all4. create a virtual optical drive. for details about how to load iso, see nim or virtual optical drive installation system 5. client boot from scsi