Solaris uses the ndd command to set the Nic speed

Solaris uses the ndd command to set the NIC rate 1 to view the NIC-related parameter ndd-getdevbge0 & lt; arg & gt; to view the current parameter value such as & quot; ndd-getdevbge0adv_autoneg_cap & quot; check whether Nic adaptation is enabled in solaris. If you do not know the parameter name, use the Command & quot; Solaris to use the ndd command to set the NIC rate 1. check the NIC-related parameters ndd-get/dev/bge0 and check the value of the current parameter, for example, "ndd-get/dev/bge0adv_autoneg_cap". check whether the Nic adaptive function is enabled in solaris. If you do not know the parameter name, use the command "ndd-get/dev/bge0 /? "Check all parameters. the read only parameter cannot be modified. 2. change the Nic parameter to ndd-set/dev/bge0. For example, if the adaptive "ndd-set/dev/slave 0" is disabled and the NIC is interrupted, you must manually modify the following parameters: "adv_1000fdx_cap, adv_1000hdx_cap, adv_100T4_cap, adv_100fdx_cap, adv_100hdx_cap, adv_10fdx_cap, adv_10hdx_cap ", these parameters correspond to the speed of 1000/100/10 m and fdx/hdx full/half duplex. You can also check whether the network is connected to "ndd-get/dev/bge0 link_status" and the current Nic transmission rate "ndd-get/dev/bge0link_speed. Of course, the NIC transmission rate is also related to the switch port and whether the network specification is supported. if the network specification is set incorrectly, the network will be disconnected.