How to configure multi-line ADSL in Linux

Article Title: how to configure multi-line ADSL in Linux. Linux is a technology channel of the IT lab in China. Includes basic categories such as desktop applications, Linux system management, kernel research, embedded systems, and open source.

This document describes how to configure dual-ADSL and multi-ADSL lines.

How to configure multi-line ADSL in Linux

Powered by KindGeorge http://kindgeorge.at.3322.org \ after a period of observation, it proves that the operation is good, now the setting process and method to sum up, welcome to correct.

This document describes how to configure dual-adsl and multi-adsl lines.

Lab environment:

Operating system: RedHat7.3

Two adsl instances, long term observation of line stability, dynamic IP address, bandwidth 2 M,

Three NICs: eth0 tulip, connected to the intranet

Eth1 3c59x, connected to the first adsl

Eth2 8139too, connected to the second adsl

Ethn xxxx, (if there is still ....)

Objective: to share the load by using two adsl networks to achieve simple load balancing and drive intranet access.

　　1. add a Nic

Insert the network card and start the machine. if you need to access the Internet through dual-line connection, you need three network cards. you can also refer to other information to configure the network card.

Configure to find the corresponding model module, for example, eth2 is 8139 Nic

[Root @ kindgeorge root] # vi/etc/modules. conf

Alias parport_lowlevel parport_pc

Alias eth0 tulip

Alias eth1 3c59x

Alias eth2 8139too

Add new lines to eth2

　2. configure adsl

Method 1:

(1) run the adsl-setup program and you will be prompted to complete the configuration process step by step.

Create a dial-up profile for ppp0 and ppp1 and save the configuration, typically stored in/etc/sysconfig/network-scripts/ifcfg-ppp1

(2) determine the/etc/sysconfig/network-scripts/ifcfg-ppp0 file, where the PIDFILE parameter is set:

PIDFILE =/var/run/ppp-adsl.pid

Modify the/etc/sysconfig/network-scripts/ifcfg-ppp1 file and set the PIDFILE parameter:

PIDFILE =/var/run/ppp-adsl1.pid

If you have more lines, you can continue to add 0, 1, 2, 3... and so on.

This is to enable different dialers to use different PIDs. If this parameter is not modified, the second line interface cannot be started.

(3) the configuration file is generally:

USERCTL = no

BOOTPROTO = dialup

NAME = DSLppp1

DEVICE = ppp1

TYPE = xDSL

ONBOOT = yes

PIDFILE =/var/run/pppoe-adsl1.pid

FIREWALL = NONE

PING =.

PPPOE_TIMEOUT = 20

LCP_FAILURE = 3

LCP_INTERVAL = 20

Clampm SS = 1412

CONNECT_POLL = 6

CONNECT_TIMEOUT = 60

DEFROUTE = yes

SYNCHRONOUS = no

ETH = eth2 (corresponding to the NIC of the new line)

PROVIDER = DSLppp1

USER = new username provided by isp 2

PEERDNS = no

[1] [2] [3] Next page