First, configure the VM to use a CD to start slax. we will not introduce SlaxLinux7.0.8: release. Example: root @ slax # fdisk/dev/sda
First, configure the VM to start slax with a CD.
SlaxLinux7.0.8: http://www.centoscn.com/CentosSoft/linux/2013/0809/1191.html available
After entering the system, open the terminal to partition and format the hard disk. Example:
Root @ slax # fdisk/dev/sda 1. enter "n" to create a new partition. 2. select "p" to create a primary partition. 3. enter the partition number "1"; 4. select start sector: press enter to use the default value. 5. select End sector: Enter the enter key and use the default value (that is, use the entire disk space). 6. enter "t" to select the partition type: then enter Hex Code as "83"; 7. enter "w" to write partition information to the hard disk. root @ slax # mkfs. ext3/dev/sda1
Mount a new partition
root@slax# mount /dev/sda1 /mnt
Configure the IP address (download and install the tool)
root@slax# ifconfig eth0 192.168.8.32 netmask 255.255.255.0
Configure the default gateway
root@slax# route add default gw 192.168.8.1
Configure DNS
root@slax# echo "nameserver 202.102.224.68">>/etc/resolv.conf
Download and install the tool
root@slax# cd Desktop root@slax# wget http://backtrack.serveftp.com/backtrack/misctools/slax6-install.kmdr root@slax# kmdr-executor slax6-install.kmdr
Set and install as shown in
After installation, restart the system.
root@slax# reboot
The startup is successful as follows:
Enter the user name root password toor to log on
Slax login: root Password: toor to start the graphic interface (as shown in) root @ slax # startx