Linux Desktop 4.0 installation diagram (1)

Original Black key. red Flag Linux Desktop 4.0 boot hard disk from a floppy disk the most detailed installation diagram 1 preparation before installation & nbsp; 1, officially purchased or downloaded Red Flag Linux Desktop 4.0 installation CD or image files, official Download: linux.com/xiazai/xiazai.php? Id1325> http://www.redflag-linux.com/

Original Black key.

How to install a hard disk on a floppy disk in Red Flag Linux 4.0

1. preparations before installation
1. officially purchase or download the installation CD or image file of Red Flag Linux Desktop 4.0,
Official Download: linux.com/xiazai/xiazai.php? Id = 1325 "> http://www.redflag-linux.com/xiazai/xiazai.php? Id = 1325 (basically cannot be downloaded)
Image Download: http://www.scsi.cn/soft/soft_list.php? Soft_type = 375 (ultra-fast)
2. leave at least two partitions in the hard disk for system use. 3G or more partitions are recommended for Mount points. about M is suitable for swap partitions and the system format is random, the installation process is reformatted.
3. one boot disk for red-flag Linux Desktop 4.0. Production method see linux.com/source/howto/dt4install#"> http://www.redflag-linux.com/source/HOWTO/dt4install.pdf to create a Linux4.0 installation boot disk
Alternatively, extract the Dosutils directory from the rfdesktop4.iso file of the installation image file of Linux Desktop 4.0 using WinISO, enter the dosutils directory under DOS, and start the installation program when running autoboot for installation.

In addition, you can directly start the installation program from the CD. the installation steps are roughly the same.

II. Start Installation
1. from bois, set the soft drive to the first boot, put it into the red-flag Linux Desktop 4.0, install the boot disk, and then restart. if there is no accident, it will appear as 1

2. no operation. the next screen is automatically displayed in 10 seconds, as shown in figure 2. 3. you are prompted to use the hard disk for installation. click next, as shown in figure 3. 4. use the light Mark key to select the rfdesktop4.iso partition of the image file. The four partitions of the hard disk are listed in the figure: /dev/hda1,/dev/hda5,/dev/hda6,/dev/hda7 select the partition of your image file. you do not need to enter the "directory containing the image", and press enter, the program began to search for the image file rfdesktop4.iso, after reading (picture Linux-04) 5. select and agree to the software agreement. click "next" unless you do not want to install the software. 6. select the installation type. generally, select "typical installation ". 7. configuring partitions is the most critical step. be careful with the configuration, select "use Disk Druid to manually partition", and click "next", as shown in Figure 7. List the detailed information of each partition, which is more intuitive at a glance. here, the/dev/hda5 (4.8G) is used as the Mount point to install the system, and/dev/hda6 (252 M) is used as the swap partition. The settings are as follows: Here, I will first create a mount point, where the Mount point is placed in the/dev/hda5 partition, that is, the original (D disk). The Mount point creation procedure is as follows: Click "/dev/hda5" to select 8