Schindler changes Uboot boot logo for embedded 4418 Development Board android4.4-

This article goes from Schindler to Forum: http://www.topeetboard.com

In the iTOP4412 Development Board Android startup appeared three logo, is the Uboot logo, the core of the
Logo, as well as a system logo.
However, there are two fewer in the iTOP4418 Development Board. This is the case: both the uboot and the kernel display the same
Logo, the time to run is read:/home/4418/android/device/nexell/drone2/boot in the
Logo.bmp.

In order to display their own logo, in fact, just find a picture to replace the original picture can be.
The original picture:

The modified Picture:

Note that the format and parameters of the picture can be seen by opening its properties parameter under Win7:

The size is 1024x768 pixels, bit depth: 24. Pay special attention to this property.
The modification was using the "GIMP" as a drawing tool. Here's a brief explanation of the process.
After you open the software, zoom the image by right-clicking on the picture

When you open the Zoom image panel, you adjust the width and height. To prevent a proportional change in width and height, you can unlock a
Under Small and medium squares are shown.

When the values are filled in, click Zoom to complete the zoom.
Down is the export image, click on the file:

Select Export as:

Then choose a good path and picture format, export, image format changes are complete.
In different screen slices are not the same, for just the size, suitable for 9.7 inch screen. Users also have to be based on their own screen
The size of the screen to set the picture size.

Schindler changes Uboot boot logo for embedded 4418 Development Board android4.4-