Simple setting of Solaris Time Synchronization

Simple setting of Solaris time synchronization 1. copy the ntp server configuration sample as the ntp configuration file # cp-p/etc/inet/ntp. server/etc/inet/ntp. conf2, edit ntp. conf to configure the server # vi/etc/inet/ntp. conf: replace server127.into the original file... simple setting of Solaris time synchronization 1. copy the ntp server configuration sample as the ntp configuration file # cp-p/etc/inet/ntp. server/etc/inet/ntp. conf2, edit ntp. conf to configure the server # vi/etc/inet/ntp. in the original file, change the XType of the server 127.127.XType.0 preferfudge 127.127.XType.0 stratum 0 to 127.127, which indicates local, that is, server 127.127.1.0 preferfudge. 1.0 stratum 0 and comment out the four lines at the end of the file. Otherwise, the system will prompt that/etc/inet/ntp cannot be found. keys file # keys/etc/inet/ntp. keys # trustedkey 0 # requestkey 0 # controlkey 03. start the ntp service Solaris 8 & 9 #/etc/rc2.d/S74xntpd stop #/etc/rc2.d/S74xntpd startSolaris 10 # svcadm disable svc: /network/ntp: default # svcadm enable svc:/network/ntp: default check status # svcs svc:/network/ntp: default if it is online, it is normal if it is maintenance, run # svcadm clear svc:/network/ntp: default to check whether Restore to normal 4. wait a while and check the server status # ntpq-p remote refid st t when poll reach delay offset disp ================ ========================================================== ======================================= * LOCAL (0 ). LCL. 0 l 51 64 377 0.00 0.000 10.06 If there is * in front of the LOCAL, the server works normally. Client settings 1. create the ntp client configuration file # touch/etc/inet/ntp. conf # chown root: sys/etc/inet/ntp. conf2, edit ntp. conf, the server that sets the synchronization time # vi/etc/inet/ntp. the conf content is as follows: server server1-ip-address preferserver server2-ip-addressserver server3-ip-address replace server-ip-address in it with the ip address of the server. If there is only one server, you can enter the first line. if multiple servers provide redundancy, you can enter the line and add the prefer flag after the preferred server. 3. start the ntp service (same as step 3 of the server setting) Solaris 9 #/etc/rc2.d/S74xntpd stop #/etc/rc2.d/S74xntpd startSolaris 10 # svcadm disable svc: /network/ntp: default # svcadm enable svc:/network/ntp: default check status # svcs svc:/network/ntp: default if it is online, it is normal if it is maintenance, run # svcadm clear svc:/network/ntp: default: Check whether the synchronization is normal again. 4. wait a while and check the synchronization status. # ntpq-p remote refid st t when poll reach delay offset disp ============ ============================ ========================================================== =========== * Pcp0000652pcs.cn. LCL. 1 u 62 64 377 0.93-26.011 0.87 see the front *, and the reach value keeps getting bigger, and the disp value keeps getting smaller, it works normally.