Telnet remote login configuration for switches in packet tracer

Experimental Objectives:

<1> Master the way to configure the switch using Telnet.

Technical principle:

<1> Configure the management IP address of the switch to configure the user name and login password for the Telnet user.

<2> switches, routers have many passwords, set these passwords can effectively improve the security of the device

<3>switch (config) #enable password xxx password to enter privileged mode

Switch (config-line) # can set the console port and vty remote login password

Switch (consfig) #enable password 123123

Switch (config) #line console 0

Switch (config-line) #password 112233

Switch (config-line) #login

Switch (config) #line vty 0 4

Switch (config-line) #password 1234

Switch (config-line) #login

Experimental steps:

New Packet tracer topology diagram

Open PC1 set the IP address.

Open the Terminal input command for your PC

En

Conf t

Inter VLAN 1

IP address 192.168.1.1 255.255.255.0

No shutdown

Exit

Enable Password 123123

Line vty 0 4

Password 112233

Login

End

Show run

Turn on PC CMD

Ping 192.168.1.1

Telnet 192.168.1.1

password:112233

Password:123123 (enter enable)

Show runing

Telnet remote login configuration for switches in packet tracer