Solaris Internet Configuration

If you do not select the default mode when installing the solaris10 system, you have selected the desk-session mode for installation. There is no interface for installation in English, and a few garbled characters are running in the middle.

The installation is complete after selecting F2 at will.

After the resolution is set, the system crashes after the cancellation. The graphic interface cannot be started.

 

After a long time, do not toss, reload.

This time I installed it on the Chinese interface. Except for the hard disk partitions in the last few steps, they were basically the same. I, that is, F2, passed.

A long time after reinstalling... Finally, I went in.

This time, we will not go into the KDE interface. The JAVA system interface is friendly and similar to window system operations.

 

Right-click the resolution and choose Properties.

This time I went online, and it took me two hours to get online. Finally, I can access the Internet.

Online error GuidanceArticleI won't get it. Write it to me:

A: Set the Bridging Mode for virtual machines.

B: Open the following n files, create one, and save it.

1. ipsettings: ETC/hosts: for example:

2. Set the subnet mask: ETC/netmasks, for example:

 

3. Gateway settings: ETC/defaultrouter for example:

 

4. DNS settings: ETC/resolv. conf, for example:

 

5. nsswitch settings: ETC/nsswitch. conf, for example:

 

After the preceding settings, you can access the Internet normally.