Run it Linux

Just get MiZ702, is his "appearance" deep attraction, the core board and the form of the bottom plate let her look, powerful and mysterious ~ ~

Beneath the gorgeous exterior is the equivalent of it, and we'll test it with Linux!

The onboard TF card has been prepared for us, the boot file, and the image file. Just turn on power Linux to run smoothly on MiZ702. Before we press the Power key, we need to do some preparatory work and note some things.

1, ensure that the SD card is plugged

2, to ensure the success of USB to serial port drive, if the driver is found to be unsuccessful, more than a few USB interface to try, preferably plugged into the computer behind the USB interface.

3, the serial port set to correct, otherwise may not be able to enter, set as shown:

4, after the board power, the serial port is recognized correctly, and then click the serial debugging Software "Connection" button.

USB to serial port drive I use the Pl2303_prolific_driverinstaller, I will upload to the attachment, after decompression, double-click on the exe file, you can install the driver. Prompt to restart the computer after installation is complete. After rebooting, we connect the MiZ702 usb-232 interface to the USB interface of the computer.

Serial assistant, is our necessary interaction with Linux tools, so choose a good serial port assistant is necessary. I choose SecureCRT, this is the best one I have used, you deserve to have. The concrete usage is very simple, oneself groping under, should will use, I do not introduce in detail, have the need of words I again do separate tutorial.

OK, now look at which COM port the board is connected to, and I'm connected to Port 5:

Then use SECURECRT to create a new serial port:

Finally reminded, the above 4 points have been remembered, then press the power, and then even "connect" it Pro ~ ~

We see the serial port carefree promised a bunch of information, we do not care about it:

If you see the last two lines shown, then congratulations, Linux has started successfully! VGA found a picture display, connected to the HDMI also has an image output, plug in the network cable, the light is also lit. But this is not the point, but when you typed a Linux command to SECURECRT, Linux gave you a response, then really feel that Linux is running!

Enter the LS command to display the files under the current folder:

Input Command VI Osrc.txt creates a new Osrc.txt file and can be edited:

Double-click the capital letter Z two times to exit VI and enter the LS command again:

There is one more Osrc.txt file at this point.

Go ahead and knock out all the Linux commands you know, and now MiZ702 is a small computer embedded in a Linux system.

Run it Linux