When you insert a USB flash drive, the following error occurs: [sdb] NoCachingmodepagepresent [sdb] Assumingdrivecache: writethrough and use fdisk-l to check the USB flash drive. (in fact, this is useless. just look at it) the following are the operations (only two steps are required): 1. go to the dev directory and check the device name of your USB flash drive. I am using sdb2. mount: mount-t
When you insert a USB flash drive, the following error occurs: [sdb] No Caching mode page present [sdb] Assuming drive cache: write through and then use fdisk-l to check the USB flash drive (in fact, this is useless, just look at it) the following are the operations (only two steps are required): 1. go to the dev directory and check the device name of your USB flash drive. my name is sdb 2. mount: mount-t
USB flash drive insertion prompt:
[Sdb] No Caching mode page present
[Sdb] Assuming drive cache: write through
Use fdisk-l to check the USB flash disk (in fact, this is useless, just look at it)
The following are the operations (only two steps are required ):
1. go to the dev directory and check the device name of your USB flash drive. my name is sdb.
2. mount: mount-t vfat/dev/sdb/mnt/udisk
Note: for a fat-format USB flash drive, run the mount-t vfat/dev/sdb/mnt/udisk command.
For ntfs format USB flash drive, mount command: mount-t NTFS-3G/dev/sdb/mnt/udisk
If there is no/mnt/udisk folder, you can create
Mkdir/mnt/udisk
You can ~
However, ntfs format to mount, you need to download a ntfs-3g-2011.4.12-5.el5.i386.rpm package, install ~
Baidu click this package name, go to CSDN download...