Upgrade strongst6000 from CatOS to Native IOS

1. Back up the configuration of CATOS and MSFC.
2. Place the IOS file in the flash card of slot0. Like c6sup12-jsv-mz.121-11b.EX1

3. Run the dir slot0 command to confirm that the file is already in the flash card of slot0.

4. Configure the Catos startup parameters. Next time, the system will be started to ROMMON:

Console> (enable) set boot config-register 0x0

5. Switch to MSFC:

Console> (enable) session 15

6. Modify MSFC configuration parameters:

Router # configure terminal

Machine (config) # config-register 0x2102

Router (config) # end

Router #

00: 08: 02 :%SYS-5-CONFIG_ I: Configured from console by console

Router #

7. Save the configuration and return to the switching status.

8. Restart the vswitch. And enters the ROMMON status

9. Enter the following command in the ROMMON status:

Rommon 1> CONFIG_FILE =

Rommon 2> sync

Rommon 3> boot slot0: c6sup12-jsv-mz.121-11b.EX1

10. Format sup-bootflash after startup:

Router # format sup-bootflash:

11. Copy the system image from slot0: To sup-bootflash:

Router # copy slot0: c6sup12-jsv-mz.121-11b.EX1 sup-bootflash:

12. Set the relevant startup parameters to restart:

Router (config) # boot system flash sup-bootflash: c6sup12-jsv-mz.121-11b.EX1

Machine (config) # config-register 0x102

Router # write memory

Router # reload

Article entry: csh responsible editor: csh