c1600

that the flash file is followed by the colon :), after the command is executed, the existing IOS size and file name of flash are displayed, as shown in the following figure: 1. rommon 1> dir flash: File size Checksum File name2179331 bytes (0x214103) 0x7b95 c1600-nsy-mz_112-15a_pIf both the File name and File size meet your requirements and are correct, you do not need to upgrade them. This may be because of a problem with your config-register settin

bytes (0x214103) 0x7b95 c1600-nsy-mz_112-15a_p If the two items of File name and File size are inconsistent with the previous snapshots of the system, you need to restore the operating system. In this case, the administrator can recover the system based on the IOS backup and use the "TFTP" and "XMODEM" methods. The following describes the preparations before the upgrade and backup. 1. Select transmission protocol There are three methods to upg

Different IOS versions and platforms have different content in each feature set. The specific feature content is subject to the Release Notes of the corresponding IOS version. IOS name is generally in the following format: PPPPP-FFFFF-MM PPPPP: IOS platform FFFFF: feature set MM: running environment and packaging ModeCiscoIOS Platform As5200 Cisco AS5200 Universal Access Server Ca1003 Cisco Advantage 1003 Ca1005 Cisco Advantage 1005 Cpa1003 Cisc

. After the command is executed, the existing IOS size and file name of flash are displayed, as shown below:Rommon 1> dir flash:File size Checksum File name2179331 bytes (0x214103) 0x7b95 c1600-nsy-mz_112-15a_p If the two items of File name and File size are inconsistent with the previous snapshots of the system, you need to restore the operating system. In this case, the administrator can recover the system based on the IOS backup and use the "TFTP"

the eicom card. 2, upgrade the Cisco 1603 Router iOS: Figure II, use Cisco router instead of Eicon WAN Interface card to connect frame trunk road The network transformation scheme in the diagram "using Cisco router instead of Eicon WAN Interface card to connect frame trunk Road" is visible, need the router to connect the network of a end to B end. In order not to affect the network structure and configuration of B-terminal and its application, the router of a-terminal should adopt Nat meth

Directory:ap1g2-k9w7-mx.153-3.jabIos Image size:1290752Total Image size:11387392Image feature:wireless lan| LWAPPImage family:ap1g2Wireless Switch Management version:8.0.72.236Eight, after about five minutes of the brush process, you can enter the system*mar 1 00:00:38.027:%sys-5-restart:system restarted--Cisco IOS Software, C1600 Software (ap1g2-k9w7-m), Version 15.3 (3) JAB, RELEASE Software (FC1)Technical Support:http://www.cisco.com/techsupportCo