500 yuan for customized Bluetooth switch Software Requirement Specification
Bluetooth switch software requirements
The software features are as follows:
1. The developed mobile phone Bluetooth APP should be applicable to Android phones and Apple mobile phone systems.
II. the Bluetooth APP software control switch is enabled and disabled. A mobile phone can be paired with multiple switches. You can set the default automatic connection switch. When the software is enabled for the first time, the default switch control interface is automatically displayed, slide the interface to the left and right to switch between different Bluetooth modules. Based on the user's choice, the bluetooth module automatically connects to the corresponding switch. When switching, the bluetooth module starts to connect to the corresponding bluetooth module, if the user leaves the Bluetooth transmission range halfway, the Bluetooth status is disconnected, and the mobile phone enters the transmission range again, the user clicks the connection, and the mobile phone software starts to connect to the interface.
3. The software interface uses a single switch as the interface. By default, it is a switch. You can add or delete multiple devices by yourself.
4. There is a setting button at the bottom of the interface. You can click it to enter the setting interface. The content is as follows:
1. Modify the name of the bluetooth module
2. Change the password (after successful pairing, you can change the pair password)
3. Set as the default device
5. because the switch and the mobile phone Bluetooth are dual-control, the switch itself can be turned off, after the switch operation on the phone should make the corresponding display. (The software must work with the hardware to issue commands.) You can use the software to control the touch keys on the switch panel on your mobile phone to implement the same functions as the touch keys on the switch panel:
Query Switch Status: AT + PIO [port number]? Reply OK + PIO: [port number] [Result] (1 = on; 0 = Off)
Short-touch switch light
Open AT + PIOB1 reply OK + Set: B1 off AT + PIOB0 reply OK + Set: B0
Hold down the light for 3 seconds
Open AT + PIOA1 reply OK + Set: A1 close AT + PIOA0 reply OK + Set: A0
Alarm Control by 8 seconds
Open AT + PIO91 reply OK + Set: 91 off AT + PIO90 reply OK + Set: 90
6. Set a code to be sent by the switch (AT + PI081). After receiving the code, the mobile phone will send a warning. (The software will handle the Code only after the hardware commands are sent)
7. The software supports automatic updates. When a new version of the software is released, the system will prompt you to update the software. After you click "OK", you will be prompted to download and install the software automatically (this function will be released by Party B ).