Scenario
After the first installation of the system, the usb cannot be used. The usb serial interface driver is not installed. It is normal that the NIC driver cannot be installed. How can I install the driver in this case?
Solution
- Check whether there is no usb driver first. You can view the device management. There is an exclamation point in front of the usb device. If no, that is to say, the usb driver is normal. Generally, if no driver is available, the usb flash drive will not be available. You can solve the problem that the usb flash drive cannot be used in the following ways:
- Open Control Panel-> Add device-> insert a USB flash drive and add the device;
- Set usb to enable in bois;
- You can burn the driver or download the driver extension version to a CD, and install the driver on the CD. The driver extension version contains the universal NIC Driver. Of course, you can also just download the universal NIC Driver; install the NIC Driver by using the driver wizard;
- The following describes how to install PE on a USB flash drive. Because you have installed the system, you can only install PE without copying the system. Install PE on the USB flash drive and search for it on the Internet. Here I only recommend the [computer store USB flash drive boot disk production tool ]. After PE is installed, set the computer usb as the system boot item in bois so that you can enter PE through the usb flash disk. After Entering PE, you can access the usb flash disk where PE is located, it is equivalent to accessing the system disk. Copy the USB flash drive to your computer so that you can install the driver.
Summary
- A backup is required for the driver. Both 32-bit and 64-bit backup is required. You can use the driver Wizard to back up the system, or use one-click gost or one-click Restore to back up the system.
- You can install PE on your USB flash drive for use from time to time. If you want to use it as a USB flash drive, you can also use it as a boot disk.