Computer Pack 13 Tutorial WIN7,WIN8.1,WIN10 command line Configure IP address

WIN7,WIN8.1,WIN10 command line configuration IP address graphic tutorial come on! It is known that the modified IP address can be implemented in the system's own "network and Sharing Center", but sometimes it may be impossible to access the interface for a variety of reasons, such as WIN10 Preview version 10049 and above. If the user needs to set a static IP to be able to achieve normal network communication, then look at the WIN7,WIN8.1,WIN10 command line configuration IP address graphics tutorial can solve the problem Oh!

method is not difficult, suitable for win7/win8.1/win10 and other systems, only need to remember a set of commands, the steps are as follows:

1. Open a command prompt and enter the netsh rear carriage return

2, then enter interface after the return

3. Input IP, enter

4, enter the set address "connection name" static new IP Address Subnet Mask Gateway 1, and then return

Note that the above command needs to be modified according to user requirements, the connection name can be referenced in the "Network Connection" name modification, support Chinese, but the quotation marks in English. There should be a space between each item, and finally enter "1", which represents OK. You can refer to the following example:

Set Address "Ethernet 3" static 192.168.1.108 255.255.255.0 192.168.0.1 1

5, you can also put the above command one-time input, but to ensure that does not wrap: netsh interface ip set address "connection name" static new IP Address Subnet Mask Gateway 1

Example: netsh interface ip set address "Ethernet 3" static 192.168.1.108 255.255.255.0 192.168.0.1 1

In addition, you can also use similar commands to modify DNS, the same format as above, as long as the "address" to "DNS" can: netsh interface ip set DNS "Ethernet 3" Static DNS address

It is important to note that the system IP becomes static after the modification. If you do not meet the needs of users, you can use the system's own Network "Troubleshooter" for automatic repair, restore dynamic IP. Of course, the IP address can also be restored by ordering the Netsh interface ip set address "connection name" DHCP, and the DNS address can also be restored by commanding the Netsh interface ip set DNS "connection name" DHCP.