On the tplink router, how do I register a peanut shell account?

I. Application introduction

Our router is embedded with a peanut shell client. After logging on to the peanut shell domain name on the router, we can dynamically associate the WAN port IP address of the router with the IP address of the peanut shell domain name. If you need to access the server under the vro through the Internet, you can use this domain name to access the intranet server by setting the virtual server on the vro and logging on to the peanut shell domain name, you do not need to care about dynamically changing IP addresses.

When logging on to the peanut shell domain name on the vro, we need to register the peanut shell account first. The following describes how to register a peanut shell account on a vro.

 

II. Setting method

1Go to the DDNS settings page

The computer uses a network cable to connect to the router's LAN port or wireless connection router signal, open the browser, clear the address bar, enter the management address tplogin.cn, enter the management password of the router, enter the router management interface.

ClickApplication Management> DDNS, ClickEnter, As shown in the following figure:

2, Registered peanut shell account

After entering the settings page,Service providerSelectPeanut Shell (Www.oray.com), As shown in the following figure:

ClickRegister a new account, The page jumps to the peanut shell official website, enter the relevant parameters according to the page prompt, as shown in the following figure:

SelectPersonal ApplicationsTo register successfully, as shown in the following figure:

3, Login peanut shells

After the account is successfully registered, you can enter the account and password of the account on the router DDNS interface, and clickLoginAfter the logon is successful, the corresponding domain name information is displayed on the interface, as shown in the figure below:

In this case, the Internet user can use the peanut shell domain name to access the intranet server.

Note:: After the port of the intranet server is opened in the vro, the Internet user can access the intranet server.