Practical Training Lesson 2: preliminary installation of computer software

Practical Training Lesson 2: preliminary installation of computer software

 

Training Content:CMOS settings and disk partition formatting before computer operating system installationPractical lesson:2 lessons

Training location: Computer assembly and maintenance lab

Purpose:

1. master the basic settings of CMOS.

2. Correct disk partitioning.

Practical training software:

1. CMOS simulation software: download.

2. Hard Disk Partition fdisk simulation program: Download

Training Content and steps:

1. Check the device

Check the computer used in the last practical training class and solve the problems in time to ensure the normal operation of this practical training.

Ii. Set CMOS

1. Set inbound CMOS;

2. Call the default system settings;

3. Set the boot from the CD (CDROM). When the boot starts, the soft drive does not perform self-check;

4. Set the security option to system and set the system security password to 123456.

4. Save and exit.

Note: The other options are adjusted as needed.

Iii. Simulated partitioning of disks

1. Run the fdisk full simulation program (FD) for the hard disk partition)

2. View partition information of the partition system. Note: In this simulation system, there are two hard disks (Hard Disk 1 and Hard Disk 2). Check the capacity of these two hard disks? Enter two hard disks to view the partition information of each hard disk (Please record ).

3. Create a partition on the second Hard Disk: The partition must be divided into a primary partition primary DOS partition (Capacity 2400 m ), An extended partition extended DOS partition ( 4000 m ), The extended partition is then divided into two Logical Disk logical dos drives (capacity: 2500 m And 1500 m ); After the disk is created, write down the drive letter and capacity of each Logical Disk on the two hard disks, and study the rules for drive letter allocation.

4. delete partitions on the first hard disk: Delete the Logical Disk, delete the extended partition, and delete the primary partition.

5. Follow the steps in step 3 to create a new partition on the first hard disk. Required: Primary Partition 3200 m , The two logical drive letters of the extended partition are 200 m And 1200 m . Note: after creating the primary partition of the first hard disk, you must activate the partition (active partition) to load the system file and start the system.

Iv. Questions, discussions, and summaries

The questions that may occur during the simulated experiment are asked by the teacher and answered by the students. If you have any questions, you can ask them. Then, each student will summarize the training.

5. Assignment

Write the lab report for this practical training.