2014 TI Cup undergraduate electronic Design competition regional competition use of instruments and devices, equipment



2014 TI Cup undergraduate electronic Design competition regional competition use of instruments and devices, equipment
A) 3a/30v two-way regulated power supply (can be paralleled);
b) 60MHz oscilloscope;
c) Three-bit half-digital multimeter;
d) Low frequency (10MHz) signal source;
e) Low frequency AC millivolt meter.
1. ay-ldc1000 Evaluation Board (must be used in the game, TI according to the number of registrations 30% allotted).
2. AY-TPA3112D1 Evaluation Board (available in the title, TI is allotted according to the number of entries 25%).
Note: The above two development Board TI according to the allotment ratio has been sent to each division organizing committee, please each participating colleges and universities themselves to the respective division organizing committee to claim.

For related design materials, please visit Hangzhou Ayan Industry Information technology company site (www.hpati.com).

1. Enameled Wire: Current 2 A and below.

2. Benchtop omni-directional microphone with greater sensitivity than -45dbv/p. The plug diameter is 3.5mm and the output impedance is 1kW ~ 2.2kW.
3. Combined paper basin mode electric horn. Rated Power 5 W. Rated Impedance 8 W.
4. USB Horn for the computer (power not exceeding 1W).

5.1W White LED light emitting tube.
6. LCD graphics dot matrix display.
7. High-power transistor or MOS tube (6A).
8. Four rotor aircraft: unlimited size, attitude and flight control with TI Company Controller.

9. Safety net (for four-rotor aircraft).

Let's get to the quiz.

2014 TI Cup undergraduate electronic Design competition regional competition use of instruments and devices, equipment