Step one: Open your computer's data-dog data recovery software, enter the software main interface, select "Deep Recovery" mode, as shown in the following figure.
Step two: As shown in the following figure, select the disk to be scanned in area 1, and click on the OK Key of area 2 to enter the data recovery progress bar.
Step three: Wait for the data scan progress bar to reach 100%, as shown in the following figure, because deep recovery needs to search each sector, so slow, please be patient.
Fourth step: After the scan is complete, the software automatically enters the "Restore File Selection Interface", as shown in the following figure. In deep recovery mode, the files that are searched are sorted by file type. You can select the type of file you want to restore in zone 1, and then locate and select the file you want to recover in zone 2, and note that in deep recovery mode, the name of the search file will change, and you will not be able to search through the file name. After you find the file you want, click the file name to preview the file. Then, in zone 3, select the Save path after file recovery, and to ensure successful recovery, do not set the save location for the recovery data to the disk you are searching for. After completing the steps above, click OK within the area 4.
Fifth step: Wait for the data recovery to complete, and then click OK button, as shown in the following figure.
Step Sixth: Locate the file you recovered under the recovery path set in step fourth.