About macro base 4739z keycaps Installation

Fault Cause:

As her daughter was playing in front of her laptop, she unplugged her "ALT" keycaps and went on for more than an hour to find solutions and install them.

Analysis:

The components of each key are: X Key Frame (a key frame: middle pin; B key frame: Groove) and key cap.

Solution:

1. First, the X key frame needs to be embedded in the Key Slot (generally first A and then B );

2. Adjust the X key frame to the full level (it looks like an external whole with a fully integrated slot). At the beginning, although you have installed the X key frame, it is always tilted at one end, repeated trials won't work many times, resulting in continuous disassembly and installation. Finally, merge the X Key Frame (a and B) into the slot first (the external looks like a horizontal plane. Note that the pin of A corresponds to the pin slot of B, and the dot strength is used ), install it in the keyway, and finally install the keycaps. Everything is OK.

Summary:

When installing the X key frame, you need to be careful and think about why it will always rise. Adjust the X Key Frame (a, B) to a whole (no one is tilted), and then embed it in the keyway, in this way, the installation of the keycaps is horizontal (not after installation ).

This article is from the "Rainy it blog" blog, please be sure to keep this source http://rainy0426.blog.51cto.com/7189031/1570219

About macro base 4739z keycaps Installation