, Very simple.
The code is as follows: |
Copy code |
<EMBED src = 'address' quality = high wmode = 'transparent' WIDTH = '000000' HEIGHT = '000000' TYPE = 'application/x-shockwave-flash'> </div> '; "> |
Note that you must modify the marked parameters (in red). The following describes the parameters to be modified:
WIDTH: transparent FLASH WIDTH
HEIGHT: transparent FLASH HEIGHT
Top: The distance between transparent FLASH and the top of the space
Left: The distance between transparent FLASH and the left end of the space
The above four parameters can be adjusted based on the FLASH size and position and the location where the FLASH appears in the QQ space. However, if you want to display the FLASH in full screen mode (1024*768), you can use the above parameters, you can adjust other resolutions by yourself. This code is actually the same as that in the navigation code of the QQ space, but it is used differently.
Okay, the four parameters are described above, and the last parameter is "address ". The modification is complete! This is also very simple. You only need to find the appropriate FLASH address. How can we find a suitable flash address? There are many methods. Here we recommend some good transparent flash addresses in the QQ space, saving you the trouble of finding a flash address. You just need to copy these addresses and replace the red "address".