Alicloud designer getting started with 5-pcb Design 1

After the schematic design, the drawing board is required. a pcb file is required. There are several ways to generate a PCB file:

1. directly use File> New> PCB in the toolbar to create a PCB, as shown in figure

2. Another better method is to use the PCB generation wizard.

2.1, in files-> the bottom PCB Board wizard, click this alicloud designer new board wizard.

2.2nextt: select the size, in English or in meters

From 2.3next to the image below, the top is custom customization, and the bottom is the template. Here we will customize it ourselves.

2.4next, for example, select the details of the Board, including outline shapes, Shape Contour, rectangle and prototype, or custom. The size of the Board below is the size of the Board.

The settings on the right can be as follows.

2.5 until next to the image below. Here is the number of layers of the Board. The number in the figure below is a two-layer board. If it is Layer 4, it is both 2 and 2. Describe it with four layers

, The above and the ground are the signal layer, and the middle two layers go through the power layer.

2.6 next, select the hole type. The first is the through hole, and the second is the blind or buried hole. You can choose to see the effect. Two-panel select through hole

2.7 next, choose the main components on the board, whether to insert directly or paste the table

2.8 next, set data, line width, line spacing, and so on as required.

In 2.9, the "finish" command is displayed, and the PCB is created.

2.10 In the above figure, a black PCB is followed by a white area, which is called sheet. You can set it to make it invisible.

Method: Right-click and choose Options> Sheet to cancel the selection of the display sheet.

2.11 import the finished and encapsulated schematic diagram to the PCB, as shown in design-> Update ....

Then perform validate changes and execute changes to import the data, as shown in

 

 

Pay attention to each other and make progress together!