Analysis on vro settings

The number of users who use wireless routers does not understand the instructions and how to set them. Generally, the default settings at the factory can be used sometimes, however, at this time, wireless networks have no encryption measures, and there are security risks. Therefore, we do not recommend that you use them. Next we will take the Network Attached router as an example to explain some of the techniques used in router configuration.

1. Let's take a look at its exterior structure. On the front panel, we can see PWR lights, SYS lights, WLAN lights, and 1-4 LAN lights arranged from left to right, WAN light and a WPS light.

1. PWR: power indicator. If the power supply is off, the power supply is not connected. If the power supply is on, the power is powered on.

2. SYS: system status indicator. If the device is off, the device is initializing. If the device is blinking, the device is working normally.

3. WLAN: Wireless status indicator. If the feature is disabled, the wireless feature is not enabled. If the feature is blinking, the feature is enabled.

4. 1-4LAN: Lan status indicator. The device is not connected to the port. The device is blinking and the port is transmitting data. The device is always on and the port is connected to the device.

5. WAN: WAN status indicator. The device is not connected to the port. The device is blinking and data is being transmitted. the device is always on and connected to the port.

6. WPS: one-click Security Setting indicator. The connection is green and secure. The connection is green. The connection is successful. The connection is red and fails.

2. Let's take a look at the router's back panel. There is a WAN port and four LAN ports respectively. The WAN port is used to connect to the Internet, and the LAN port is used to connect to the computer's Nic. Connect these ports with a network cable and connect them to the power supply. Then you can configure the wireless router.

3. After all the network cables are connected, enter the IP address 192.168.1.1 In the IE Address Bar and press enter to bring up the login window. After the user name and password are both admin, you can configure the interface. User passwords and IP addresses are usually marked on the bottom labels of the vro. A Wireless Broadband Router can be connected through a wired or wireless connection. However, if this is the first configuration, we recommend that you use a wired connection.

4. For new users, the wireless router provides a convenient Setup Wizard, which can be completed in just a few steps. Next, let's take a look at how to use the Wizard to set up a wireless router.

1. Click the setting wizard on the left and click Next. As you can see, the vro supports three common Internet access methods. We should select according to the actual situation when using the vro. For Ethernet bandwidth and dynamic IP, select the corresponding option and click Next.

2. Set the wireless network. You can enable or disable the wireless network. If the wireless status is disabled, the wireless network is unavailable.

3. You can also modify the SSID and use your own name as the name of the wireless network. In addition, you can select a channel. If there are other wireless networks with the same channel, our network will be subject to a certain degree of interference, therefore, it is best to select a channel that is different from other networks.

4. The frequency band bandwidth can be set to automatic, 20 M or 40 M. It is also best to distinguish it from the surrounding network to avoid interference. After setting, click Next, after the basic network parameters are configured, you can access the network after the restart.

5. For an Ethernet static IP address, select the corresponding option, click Next, enter the IP address, subnet mask, gateway, and other basic network parameters provided by the network service provider, and click Next.

6. The next step is wireless configuration. The method is the same as above. After the wireless router is set up, you can access the network. If the dialing method is selected for ADSL, select the corresponding option, click Next, and enter the Internet account and password provided by the network service provider to complete the settings.