ArchLinux Broadband Connection IPv6 settings

In Windows, using the school's IPV6 is the default support, no additional configuration is required

But in ArchLinux, the default configuration I found that once connected to the broadband (PPPoE), it can only IPv4, unrecognized IPv6

Later found a 12 across the Strait Netizen's blog, the blog said he referred to the other side of the configuration (Eh, back again?)

And then of course I saw the Arch Wiki about the IPv6 part, and finally the configuration was successful.

The key is to use a Teredo technique called

Wikipedia says:

In computer networking, Teredo are a transition technology that gives full IPV6 connectivity for ipv6-capable hosts that AR E on the IPv4 Internet but has no native connection to an IPV6 network. Unlike similar protocols, it can perform it function even from behind network address translation (NAT) devices such as H ome routers.

Well, what exactly is the configuration?

1. Installing Teredo Support

   sudo pacman -S miredo

   Then you can sudo miredo use

   If you don't want to run the service manually every time you turn it on.

   systemctl enable miredo

   If normal ifconfig will find a more virtual network card

2. Configuration pppd (the Arch Wiki says, I don't know if it's necessary)

   Add a row to the PPPD configuration file to /etc/ppp/pppoe.conf +ipv6 save

After the reboot you will be able to see the IPV6 website when you connect to the broadband.

By the way, the school IPv6, although the speed is not fast, but with this can奿 摤AH

ArchLinux Broadband Connection IPv6 settings